Time domain
An inertia-relief / static run is enough for dynamics: the unit load cases and the load histories give every response below. The same responses come from inertia-relief via normal modes and from the modal-transient solve, for load histories of any length.
Displacement, velocity and acceleration at any node. Total acceleration includes the rigid-body part.
Relative displacement and strain between node pairs: contact and interference checks, twist and bending tracking, over more than a million time steps.
Spring, rod, beam and bush force histories (CELAS, CBUSH, CBAR, CBEAM). Shell and solid stress histories at top and bottom surfaces.
Force and moment on every concentrated mass (CONM2). Mounts of battery packs, motors, payloads and avionics can be sized from calculated forces.
Inertia-relief accelerations combined with a trusted mass, inertia and CG of the vehicle, written as contours and as CONM2 forces and moments.
Modal coordinates, the loads acting on each mode and a mode-amplification summary from the modal-transient solve.
Solvers inside FatDyn-X
Start from the inertia-relief / static run, or from the normal modes. With the modes, loads are projected to modal space and solved inside FatDyn-X.
Unit load cases from the solver (SOL 101), combined with the load histories. Gives node, element-force, stress and mass-force histories, and acceleration contours. The route for stiff structures and preliminary loads. More
A single normal-modes run (SOL 103) gives the same quasi-static answer as the unit-load inertia-relief cases (SOL 101), which remain available for stiff structures and preliminary loads. Rigid-body modes drive the accelerations and mass forces; residual-static modes supply the non-resonant shapes.
The physics of a solver's modal-transient analysis (SOL 112), without the FORCE, TLOAD and TABLED decks. Damping per mode. Accurate from t = 0 with no start-up oscillation, and non-zero initial loads are handled correctly. Vehicle loads start from 1 g, so this matters.
One set of modal stresses serves the quasi-static and the dynamic events of a duty cycle. See the solver choices.
Frequency domain
Modal frequency response for force excitation, computed inside FatDyn-X from the normal modes. NVH-type responses need only the modes and a short keyword block, in place of a SOL 111 deck with its RLOAD and TABLED cards.
Frequency domain
Response to PSD / ASD input at nodes, in element forces and in stresses, by two input paths.
Spectral moments m0, m1, m2 and m4; RMS, irregularity factor and peak rate.
A stand-alone tool converts acceleration or load time histories to PSDs and reports the number of averaged segments.
Acceleration and mass-force histories can be computed from the normal modes and the load histories, then converted to PSDs.
Verification